Achieving a Neutral PH on Victorian Tiles before Sealing in Gainsborough North-Lincolnshire

The photographs below were taken during the renovation of a Victorian tiled hallway floor at a property near Gainsborough. The floor was in good condition except for several areas of missing tiles which had been back filled with cement.

There were also two doorway sections where the owner wanted additional tiles adding to match the original. Fortunately, there was a large entrance matting covering more tiles, so I was able to take what I wanted from there to carry out the repairs.

Repairing a Victorian Tiled Hallway Floor

Work commenced with the tiling work carefully removing the tiling from under the entrance matting and then cleaning them up. The matting was then dropped into the floor so it was level with the tiles.

The sections that had been replaced with concrete were then carefully scraped out and then prepped to take the tiles level with the existing floor. I dry fitted the tiles first cutting some of them as required to match the existing pattern.

Once I was happy with the pattern, they were then secured in place with a rapid setting adhesive and then grouted. There were a couple of areas that needed this attention and the two door thresholds so this work took up the whole of day one.

Repairing a Victorian Tiled Hallway Floor

The next day the adhesive and grout had set and I was able to turn my attention to getting the floor clean and removing any remaining sealer. To do this I applied a strong dilution of Tile Doctor Remove and Go and left it to soak in for twenty minutes. The dwell time gives the product time to work into the tile and break down the old sealants and dirt. The floor was then scrubbed using a black pad fitted to a rotary machine and you could see the dirt lifting out of the tiles.

I worked in sections and used a wet vacuum to extract the dirt that had been released from the tiles. Once done I inspected the floor and spot treated any areas that needed more work.

With that done I moved onto the next step of giving the floor an acid rinse using Tile Doctor Acid Gel. This cleans up the tiles further by removing grout smears, dissolving efflorescent salts in the floor and the acidic nature of the product also neutralises the pH level of the floor after the use of strong alkaline cleaning products earlier. The floor was rinsed again afterwards, and then dried as much as possible with the wet vacuum before leaving it to dry off overnight.

Sealing a Victorian Tiled Hallway Floor

The next day the moisture levels of the tiles were checked with a damp meter to ensure they were dry enough to be sealed. The readings were fine, so I was able to apply a couple of coats of Tile Doctor Colour Grow which is a breathable colour enhancing sealer. This is a super durable product which will give great protection to the floor, especially when it is in a high traffic area such as a hallway.

My client was very happy with the result and hadn’t really expected it to come out as well as it did. Before leaving I took time to discuss aftercare and recommended the use of Tile Doctor Neutral Tile Cleaner to maintain the floor. This is a pH neutral product which will is mild enough to use every day and won’t harm the sealer. It’s supplied as a concentrate so you only need a small amount of cleaning fluid to clean the floor and so a one litre bottle will last some time.

Source: Victorian Floor Cleaning and Sealing Service in Gainsborough Lincolnshire